VarTech Systems VT190R Betriebsanweisung PDF herunterladen (Seite 22)

Panel Mounting Procedure

1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.

Panel Mounting Cutout

2. If access to the side of the monitor is not available following installation, attach the power and

video cables to the side of the monitor at this time.

3. Install the monitor in the prepared cutout.

4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along the

sides and top/bottom of the cutout in the panel. Extra lock nuts and washers are provided.

Note: Use #10-32 nuts for mounting.

5. Tighten all mounting nuts evenly to a torque of 24 inch-pounds.

ATTENTION: Mounting nuts must be tightened to a torque of 24 inch-pounds to provide panel seal

and avoid potential damage. Vartech Systems assumes no responsibility for water or chemical

damage to the monitor or other equipment within the enclosure due to improper installation.

6. Attach the power and video cables to the side of the monitor if you have not already done so.

Mechanical Drawings

Section

Mechanical Drawings

Model Description Page(s)

VT190PM 19.0” PowerVue Panel Mount Mechanical Drawing 21

VT190RM 19.0” PowerVue Rack Mount Mechanical Drawing 22

VT190WM 19.0” PowerVue Wall Mount Mechanical Drawing 23

VT190YM 19.0” PowerVue Yoke Mount Mechanical Drawing 24

1 2 ... 17 18 19 20 21 22 23 24

Keine Kommentare

VarTech Systems VT190R Betriebsanweisung Seite 22