VarTech Systems VT190R Betriebsanweisung PDF herunterladen (Seite 7)

When connecting the monitor to an analog signal source, it is necessary to use a cable that

terminates on the monitor end with an HD-15 connector that mates to the monitor’s connector, and

on the source end with an HD-15 connector or with some combination of three to five BNC

connectors, as appropriate to the source.

Provided the correct cable is used, the monitor will automatically sense and adapt to the sync type

(sync-on-green, composite separate sync, or separate horizontal and vertical syncs).

Please refer to figure 1 for location of the

HD-15 connector on the monitor’s rear panel.

2.4

Connecting the Display

2.5

Signal Connections

POWER

VIDEO IN

SERIA

-26 5 VAC

-440Hz

FUSE

POWER

VIDEO IN

SERIAL

85-265 VAC

47-440HZ

FUSE

Figure 1

Rear view of VT190 showing connectors

You can use an HD-15 connector cable or a BNC adapter cable to connect the flat panel

monitor to the host computer. The HD-15 video cable (supplied in the kit) you use with this

monitor is equipped with a conventional HD-15 connector at each end.

HD-15 Video Connector

The following table provides the pin numbers and corresponding pin assignments for the

HD-15 video connector.

Note: The following figure is the view looking into the pin end of the male connector or solder

term end of the female connector.

1 2 3 4

6 7 8 9 10

11 12

14 15

HD15

Pin Signal (HD15) Pin Signal (HD15) Pin Signal (HD15)

1 Red Video 6 Red Return 11 ID0

2 Green Video 7 Green Return 12 ID1

3 Blue Video 8 Blue Return 13 Horizontal Sync

4 ID2 9 Reserved 14 Vertical Sync

5 Reserved 10 Ground 15 Reserved

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

VarTech Systems VT190R Betriebsanweisung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Touchscreen-Monitore VarTech Systems VT190R